Posted  by 

Better Homes And Gardens Diffuser User Manual

May 12, 2017  To clean your essential oil diffuser, start by unplugging it and pouring out any excess water so you don’t spill it over the buttons. Then, put a small amount of natural dish soap on a cotton brush, and wipe down the tank and the outside of your diffuser. Once you’ve cleaned away any grime, rinse the diffuser by rubbing it with a damp cloth.

Rowenta steam station. Do not touch or remove the sole- plate cover without letting the appliance cool down.˾During use or while unit is heating or cooling, do not rest appliance on its sole- plate. Place product on its side on a firm, heat resistant, flat surface, as soleplate will be hot.˾As the appliance heats the housing becomes warm.This is normal.DUAL VOLTAGEDual voltage selection˾The appliance can work on both, 120V or 240V, AC systems.˾Be sure the dual voltage selector (E) is in the correct voltage position before oper- ating. To do this, unplug the appliance and turn the selector which is below the handle with a coin, so it is aligned with the correct voltage (either 120V or 240V).Never change selector while unit is plugged in.˾This is a 120/240 V dual voltage appliance and may be used in the United States and abroad without an electricity converter.

  1. Better Homes And Gardens Diffuser Manual
  2. Better Home And Garden Diffuser

It is recommended to clean the water container, water level sensor and ultrasonic mist chip every month and before storing. Clean it more frequently for heavy/frequent use. Clean every week for every day use. A failure to clean your unit properly will result in the diffusion screen clogging and the water container staining. Damage to the unit will occur and it will result in voiding the product warranty. Some essential oils such as orange or vetiver may cause discoloration to the plastic of the bowl. Note that this does not affect diffusion, but to keep your diffuser looking new, clean the bowl more frequently if you are using dark colored oils.

  • Jun 12, 2017  via YouTube Capture I got this one to replace a smaller and less feature wise than this one. Probably going to use this one in my room. It performs VERY well.
  • Jun 26, 2019  Buy URPOWER 300ml Essential Oil Diffuser with 6 Bottles 10ml Most Popular 100% Pure Aromatherapy Essential Oils, Aroma Gift Set Cool Mist Humidifier with 15 Lighting Modes Light for Bedroom Home Office on Amazon.com FREE SHIPPING on qualified orders.

If you are having problems with your diffuser, you can also see our troubleshooting page.

Cleaning the diffuser:

Before cleaning the externally exposed parts of your diffuser, always turn the power off on the product and remove plug from outlet and the diffuser. DO NOT clean the diffuser while it is plugged in to an electrical source.

  1. Unplug your diffuser so it is not connected to any electrical source and remove any batteries if applicable.
  2. Remove the cover from product.
  3. If your diffuser has a splash guard, slide the splash to the open position or detach it based on your model.
  4. Add some water and a small amount neutral cleanser into the water container. Avoid harsh cleansers that could corrode the unit. A neutral cleanser is one that is gentle and has ph balance. Your typical dish soap will do. You can also use vinegar or isopropyl alcohol. Avoid harsh agents such as glass cleaner, bathroom cleaner or stronger agents such as CLR.
  5. Use the cleaning brush to clean the inside of water container to remove any residual oil stain and rinse with water. Gently agitate the area around the diffuser screen. If your model does not come with a cleaning brush, use a medium bristle art brush or a dental brush. That should do the trick.
  6. When pouring out the water please pay attention to the water pouring direction. Avoid water entering the ventilation hole. If water enters the ventilation hole, try to gently shake out excess water and leave it to dry completely before trying to plug it in. Your diffuser is an electrical appliance. Avoid plugging in the unit if wet inside as it may result in damage to the unit and a shock hazard to you. Be smart and safe.
  7. If you have on hand, using an alcohol wipe is also a good choice to to finish cleaning the water basin to help eliminate odor residue and reduce staining.
  8. After unit's exterior is clean, reassemble and your unit is ready to use. Periodically, you should run a cleaning cycle.

Running a Cleaning Cycle:

Periodically, it is a good idea to run your diffuser through a cleaning cycle. If you use your unit everyday, then running a cleaning cycle monthly is a good idea. To do so, do the following:

  1. Fill the diffuser about half way with clean water (well below the fill line) and add up to 10 drops of pure white vinegar.
  2. Run the diffuser for 3-5 minutes,
  3. Empty the bowl and rinse thoroughly with clean water.
  4. Fill with water only and run the diffuser for 1-2 more minutes,
  5. Empty again and you're good to go.

Need a New Diffuser?

Aromatherapy Products are duty free!

If you are having problems with your diffuser, try these troubleshooting steps:

Note that these helpful steps to troubleshoot are for ultrasonic aromatherapy diffusers.

My diffuser does not work at all:

Better Homes And Gardens Diffuser User Manual
  • Check that there is water in the bowl and that the water level is correct. Too high or too low can result in no diffusion.
  • Ensure that you are using the correct power adapter.
  • Check that the power adapter is securely plugged into the wall socket.
  • Check that the other end of the power supply is securely plugged into the diffuser.
  • Test the power source or try an alternate power source to ensure that there is adequate power being supplied to the unit.
  • Make sure you are using only filtered water, tap water or spring water. Do not use distilled water as this affects the diffusion.

People often get water inside the diffuser through overfilling, bumping or moving the diffuser around while full. If water or essential oil enters the diffuser it will quit working. If this happens, your should unplug and clean the unit and remove any water and let it sit for a day or two to 'dry out'. Water may evaporate in a matter of hours, but essential oils take more time. After it has had time to dry, refill and try it again. The moisture will evaporate and the diffuser should work once again. If your unit still doesn't work, and you purchased it from us, then contact us.

Better Homes And Gardens Diffuser Manual

Diffusion is very weak and or lower than usual:

  • Clean your unit and run it though an cleaning cycle.
  • Make sure you are using only filtered water, tap water or spring water. Avoid distilled water as this may affect the diffusion.
  • Check for correct water level. Over filling the unit or too little water in the unit may be the cause.
  • Most diffusers vent from the bottom, so placing them on a soft surface can restrict airflow. Check that the air intake is not obstructed, and that the air flow is not restricted. Over time, hair or dust can enter the unit thought the air intake. Make sure that this is unobstructed.
  • Only operate the diffuser on a level, hard surface. DO NOT run your diffuser on a towel or any soft surface that will restrict the air flow.
  • Check to see if the water level sensor is clean and unobstructed.
  • If all is good, keep it unplugged for a few minutes, refill, and restart the diffuser.
  • If it is still very weak, and you purchased your diffuser from us, then contact us.

Water in diffuser feels hot:

  • Turn off and unplug diffuser and allow it to cool down. In some models, the water naturally will increase in temperature if you run them continuously for extended periods of time and this is normal.
  • Check that the air intake is not clogged by dust, hair or restricted or obstructed in anyway.
  • Check that the diffuser is on a level, hard surface. DO NOT run your diffuser on a towel or any soft surface that will restrict the air flow and cause the unit to overheat.
  • Clean your unit and run it through a cleaning cycle.
  • Refill and restart. If the water is still hot, and you purchased your diffuser from us, then contact us.

Lights turn on but there is no diffusion:

  • Check that the diffuser is on a level, hard surface. DO NOT run your diffuser on a towel or any soft surface that will restrict the air flow.
  • Ensure that your diffusers is not filled too high. Water should never be above the fill line.
  • Clean your unit and run it through a cleaning cycle.
  • Unplug, refill if necessary, reconnect and turn the diffuser on again.
  • Make sure you are using only filtered water, tap water or spring water. Avoid distilled water as this can affect the diffusion.
  • If it will not restart, and you purchased your diffuser from us, then contact us.

Light is blinking and there is no diffusion:

Better Home And Garden Diffuser

  • Check that the diffuser is on a level, hard surface. DO NOT run your diffuser on a towel or any soft surface that will restrict the air flow.
  • Ensure there is adequate water in the reservoir. Water should be at or just below the fill line.
  • Clean your unit and run it through a cleaning cycle.
  • Unplug, refill if necessary, reconnect and turn the diffuser on again.
  • Make sure you are using only filtered water, tap water or spring water. Avoid distilled water as this can affect the diffusion.
  • If it will not restart, and you purchased your diffuser from us, then contact us.

It still isn't working?

  • See our article on diffuser cleaning and maintenance.
  • If it still will not work, and you purchased your diffuser from us, then contact us and we will see if we can repair your unit.
  • Otherwise, check out our diffuser section for a great deal on a new diffuser. All prices are in Canadian dollars and we ship all over North America.

Need a New Diffuser?

Aromatherapy Products are duty free!