Apc Smart Ups Sc 1000 User Manual
- Apc Smart-ups Sc 1000
- Apc Smart Ups Sc1000 Manual
- Apc Smart Ups 3000 Manual
- Apc Smart Ups 1000 Software
Read online or download PDF. Page 11 / 60. APC SMARTUPS Smart-UPS 700 User Manual. APC Tools. Manuals Directory ManualsDir.com - online owner manuals library. SMARTUPS Smart-UPS 700. Manual APC SMARTUPS Smart-UPS 700 User Manual Page 11. SMARTUPS Smart-UPS 1000. Jun 04, 2018 I have just replaced the battery in my SC-1000 with a new RBC-33 from APC. The manual states i should execute a self test to clear the replace battery alarm. But the manual doesn't say how to execute a self test. There is no computer involved, so no powerchute.
7
English
450 and 700 VA
Use the computer interface port for unit monitoring and control. See section 7.
The configuration button changes the unit’s sensitivity to utility voltage variations and the low
battery warning interval. See sections 5.9 and 5.10.
The configuration LED indicates the voltage sensitivity setting and the low battery warning
interval. See sections 5.9 and 5.10.
The site wiring fault indicator comes on when the unit is connected to an improperly wired AC
power outlet. See section 4.8.
The output circuit breakers (2200 VA and 3000 VA models only) trip when the connected loads
exceed the protected receptacle’s capacity. The center plunger of the circuit breakers extend when
tripped.
The input circuit breaker trips when loads exceed the unit’s capacity. The center plunger of the circuit
breaker extends when tripped. The paddle handle on 3000 VA model input circuit breaker shows “off ”
when tripped.
Use the transient voltage surge suppression (TVSS) ground connector for the ground leads of
telephone or network line protectors. See section 4.9.
The input power connector is a power cord with a NEMA 5-15P connector for 450 through 1400
VA models. See the table below for input power connectors on 2200 VA and 3000 VA models.
The output power receptacles are NEMA 5-15R type. Optional output power receptacle kits are
available from the factory for the 2200 VA and 3000 VA models. See your dealer or call the
number at the front of this manual for more information.
HDSDR (former WinradHD) is an advanced version of Winrad, written by Alberto di Bene. Main features: separate large spectrum and waterfall display for input and output signals. Setup Instructions for HDSDR Software (for RX) Version. These instructions are based upon the following software versions. HDSDR Version 2.70; CFGSDR Version 2.6; extIO.dll file dated 5/9/2012 (part of CFGR download and install) Assumptions. These instructions are predicated upon the following assumptions. Download hdsdr.
Optional accessories can be installed in the accessory slot. See section 4.4 and section 7.
Use the battery pack connector to connect the optional external battery pack (3000 VA model
only).
Apc Smart-ups Sc 1000
